You are here: Home » Topic » Installation on DSM G600 Rev B and connecting to Pinnacle SB

Installation on DSM G600 Rev B and connecting to Pinnacle SB

FireFly Media Server (formerly mt-daapd) Firefly Media Server Forums Firefly Media Server Setup Issues Installation on DSM G600 Rev B and connecting to Pinnacle SB

This topic contains 1 reply, has 1 voice, and was last updated by  rpedde 10 years, 4 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #1532

    charles

    Hallo

    i have running a DSM G600 with mt-daapd 0.24 enabled and running.
    I can connect with itunes but i cannot connect to my pinnacle soundbridge.

    I think the problem is, that i have mt-daapd without the Roku protocol running. The Roku protocol is nessecary for connecting pinnacle soundbridges due to some licence problems between pinnacle and apple.

    Is there a full featured firefly server availabe for the DSM G600 Rev B?
    Does anybody have an idea on how to connect my devices?

    Thanks for any replies
    Charles

    #11571

    rpedde
    Participant

    @charles wrote:

    Hallo

    i have running a DSM G600 with mt-daapd 0.24 enabled and running.
    I can connect with itunes but i cannot connect to my pinnacle soundbridge.

    I think the problem is, that i have mt-daapd without the Roku protocol running. The Roku protocol is nessecary for connecting pinnacle soundbridges due to some licence problems between pinnacle and apple.

    Is there a full featured firefly server availabe for the DSM G600 Rev B?
    Does anybody have an idea on how to connect my devices?

    Thanks for any replies
    Charles

    Looks like some useful info here:

    http://forum.dsmg600.info/t619-Firefly-with-firmware-104.html

    I think that forum is where you’ll get the most help. I do some PPC builds, but only for debian and unslung. If you get one of those two running on it, you can use the packages at nightlies.mt-daapd.org.

    Or perhaps even untar the ipkg and get the binaries out of that, but I’m not sure how that would work.

    — Ron

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.