@davesanti wrote:
Rich, the router is a Linsksys (no wireless on it) that works with Vonage. For setup, I didnt assign anything to it, so I assume DHCP.
Fizze, the Sercom flash appeared to go fine… The web interface found the Slug…it went through the initial clearing .. loading and verifying.. took about 5 – 10 minutes and all looked good.
Dave
If your flash appeared to go ok and the slug is still dead then you may need to reset the sys conf area via redboot. This is documented on the nslu2 wiki here:
http://www.nslu2-linux.org/wiki/HowTo/ResetSysConf
I have had to do this myself to recover a bricked sluck and it worked for me. Just make sure that you type very carefully. Also have Linksys R63 to hand.